Applications :- Plastics Pulverizing Including PVC Recycling, Rotational Molding, Compounding and Master batching.
Dual or Twin Mill Standard Features:
Direct Drive Mills – This revolutionary design eliminates the use of industry standard belt drive. The flywheel for the rotating disks is directly connected to the motor shaft, eliminating the belt drive, bearing housing and motor adjustment fixture.
The direct drive provides 100% of the available horse power, which belt drive models do not. The direct drive saves our customers the expense of stocking expensive drive parts, bearings, seals, belts, spindle shaft or complete bearing housing assembly. The direct drive also eliminates down time due to bearing or belt failure.
Heavy Gauge Quick Disconnect Piping – The piping is heavier gauge than our competition and the clamps connecting each joint are forever clamps with positive o-ring seal to eliminate leaking of powder at the connection
High HP Efficiency Iron Motors
Large Capacity Rotationally Molded Plastic Pellet Hopper with Center Flow – Center flow eliminates hang-ups of material in the hoppers
Standard Upper and Lower Operator Work Platforms -Improved operator safety and access to everything on the machine.
Heavy-duty Mill Housings – Extra thick, heavy-duty malleable steel housings are cast in one-piece for increased safety. The mill is fitted with air inlet valve for maximum cooling adjustment of the mill housing.
Optional Variable Frequency Drives – Variable Frequency Drive starts reduce the in-rush of electricity and consumption during start-up. Reduces demand of electricity at start up which results in huge electrical savings for our customers.
High-Efficiency Blower – A high efficiency blower that creates the exact vacuum to move the product through the system at the required velocity.
Single Stud Disk Gap Adjusters Per Mill – Allow adjustment of the disk gap from outside the mill. Integrated locking mechanism on stud provides single point adjustment.
Water Jacketed Stationary Adjusting Fixture for Stationary Disks
Increased Cooling – Vacuum pipe to the mills allows for equal vacuum draw at both mills, thus increasing the airflow to the mill chambers. This allows increased cooling capabilities in the mill chambers.
Resistant Disk Technology – This disk design lasts 4-to-5 times longer than conventional disks. The disk inner clamp ring was designed based upon the inlet of a jet engine forcing the air and pellets into the mill chamber. This eliminates the pop-corning effect, the rebounding of material where pellets bounce out of the mill chamber.
Air Flow Management – Our airflow technology optimizes mill cooling so that you can use 100% of the available horsepower to grind. The design reduces air turbulence on the inlet of the mill providing better airflow for cooling of the grinding and higher output. This design also eliminates material discharge from air inlets.
Small Machine Footprint – Optimized Vertical Footprint reduce floor space requirements. Optimized vertical footprint maximizes powder discharge height. equipment is designed to accept the largest gaylord available in addition to discharging the center of the box. No need to remove piping for oversized gaylords.
Maintenance Friendly Design – Component layout design for easy access to motors, grease fittings, Motors have single point adjustor for efficient belt adjustment
Archives
Recent Posts
Categories
Calendar
Meta
Dual or Twin Mill Pulverizing System,Pulverizing Equipment
Dual or Twin Mill Pulverizing System
Applications :- Plastics Pulverizing Including PVC Recycling, Rotational Molding, Compounding and Master batching.
Dual or Twin Mill Standard Features: